The replacement display and power button assembly for the Inmotion Climber. This is the unit that sits on the stem: it carries the power button, shows your speed and battery level, and passes the control signals down to the controller.

What is in the box

• Display housing with the integrated power button
• Attached wiring loom, terminated in the waterproof round connector the Climber uses

Before you order

This is the Climber-specific part. Inmotion displays are not interchangeable across models: the RS and the Climber use different assemblies and different looms, so a display from another model will not simply plug in.

Check your connector before ordering. Unplug the existing display at the stem and compare it to the photos. If yours does not match, message us with a photo before you buy and we will tell you which part you need. That one check saves a return.

Fitting it

It is a plug and play swap rather than a soldering job. Unplug the old loom, feed the new one through the stem, seat the connector until it clicks, and refit the housing. Take your time seating the connector fully: a partly seated waterproof plug is the most common cause of a display that flickers or will not power on after a swap.

Genuine Inmotion part, stocked in our US warehouse, with US-based support seven days a week.