Featuring an SFI exclusive translucent clear with a subtle shimmer, and unique foxagon shaped venting profiles.

RIPPCAR is a Variable-Line Segmented SLA-Printed Resin PCAR. This rifling attachment uses improved geometry from Thanhtacles' Trivictus design. Utilizes segmented lines or "Rotated Intermittent Protrusions" in a new formation of 4-4-8. This PCAR is designed to mimic the properties of the bearings in BCARS without moving parts, with the final 8-line "choke" segment along with the added porting, help reduce turbulence and tail drift to ensure a stable dart trajectory.

SLA printed in a translucent resin, this low-profile PCAR is compatible with all 16mm or 5/8in OD barrels, including recessed barrels on the Lynx and similar blasters.

Be advised that SLA Resin can be more brittle than FDM printed filaments.

When installing on a barrel, ensure the fit is not too tight, otherwise forcing the RIPPCAR on will cause it to crack. If needed, sand the inside of the interfacing area a little at a time. If the fit is loose, apply a layer of tape to the barrel and try fitting it again. Repeat if necessary. Clear Scotch Tape works well for this.