Floor Scrubber Squeegee Assembly for Sanitmax SM860 Ride-on Floor Scrubber Machine. Comes with 1 set of rubber blades. Keep your machine operating its best with OEM parts. Parts are machine specific. 

How to adjust squeegee on floor scrubber

To adjust the squeegee on a floor scrubber, follow these steps:

• Turn off the Machine: Before making any adjustments, ensure the floor scrubber is turned off and unplugged to prevent accidents.
• Locate Squeegee Adjustment Knobs: Most floor scrubbers have knobs or levers that control the height and angle of the squeegee. These are usually located near the rear of the machine, close to the squeegee assembly.
• Adjust Height: Depending on the type of floor and the desired suction level, you can raise or lower the squeegee. Make small adjustments and test the machine to achieve the optimal squeegee height for effective water recovery.
• Adjust Angle: Proper squeegee angle is crucial for efficient water pick-up. Tilt the squeegee slightly forward for better performance. Use the adjustment knobs to fine-tune the angle, ensuring the squeegee blades make proper contact with the floor.
• Test and Refine: After making adjustments, run the machine over a small section of the floor to test the squeegee's performance. If streaks or excess water remain, continue fine-tuning the height and angle until the desired results are achieved.
• Maintenance: Regularly inspect and clean the squeegee blades and assembly to prevent debris buildup, which can affect performance. We suggest replacing the rubber blades every 3-4 months.