The story
Watch how OG Soap came to life
This soap started out of frustration. Supply issues kept killing my wash routine, so we built something custom instead.
Iterations A through E. Side by side scent tests. Foam that feels like shaving cream, not that dry airy stuff. This is the full journey, from first sample to final formula.
- 5 formula iterations tested
- Various slicknesses tested
- Scent comparisons
- Behind the scenes at the blending facility
Key features
pH neutral
Targeted at 7.0 to 7.2, safe on wax, sealants, and ceramic coatings.
Dense, creamy foam
Clings to the panel and slowly melts away instead of clumping off in patches.
Highly concentrated
1oz in a full foam cannon or bucket is plenty for most setups.
Skincare grade
Premium surfactants of the same grade found in high end body wash. Gentle on skin and paint.
Sun safe
Rinses clean without staining, even after fully drying on a hot panel in direct sun.
Made in the USA
Every raw material is sourced and blended domestically.
Dial it in
Dilution calculator
This soap is highly concentrated. Find your starting point based on your setup.
Foam cannon
Standard flow (up to 2 GPM)Mid flow (2 to 2.5 GPM)High flow (3+ GPM)
Wash bucket
Efficient (recommended)Extra suds and slickness
Start low and adjust from there. More soap means more foam and lubricity, but this formula performs at amounts most soaps can't match.
Not your average soap
Most soaps fake performance with cheap surfactants. This one earns it.
- Skincare grade surfactants
- Dense, creamy shaving cream foam
- 1oz per wash, ultra concentrated
- No staining, even dried in the sun
- Cheap petroleum-based surfactants
- Dry, airy foam that falls apart
- 5oz or more per wash
- Can stain trim and glass if dried
How to use
Pre-clean first
Run a touchless pre-wash to clear loose dirt and grit before any contact with the paint.
Start with 1oz
Add to a full foam cannon or bucket and adjust based on your setup and flow rate.
Wash top to bottom
Straight lines with a clean mitt, rinsing often in a separate rinse bucket.
Rinse and dry
Rinse thoroughly, dry with a clean microfiber cloth, and enjoy the slick, glassy finish.
Specifications
Frequently asked questions
Will this strip my ceramic coating or wax?
No. The formula is pH neutral, targeted at 7.0 to 7.2, and safe on coatings, waxes, and sealants.
How much should I use?
Start with 1oz in a full foam cannon or bucket. High flow pressure washers may need up to 3oz for the same foam performance.
What if it dries on the car in the sun?
It rinses clean without staining windows, trim, or paint, even after fully drying on a hot panel.
What happens if my bottle freezes during shipping?
Let it come to room temperature over a couple of days, shake it well, and it's good to go. Avoid letting it freeze repeatedly.
What's the shelf life?
Two years from the purchase date. Give the container a quick shake if it's been sitting for a while.