The Egis Clear Button Boot is a sealing cover for low-amp, panel-mount push-to-reset breakers. It replaces the standard mounting nut and keeps spray and grime out of the reset button, while the clear top lets you see whether a breaker has tripped. UV-resistant material keeps the seal tight season after season.
If you've ever mounted a push-to-reset breaker on a helm panel and watched it collect spray and grime, you know where the trouble starts. The Egis Clear Button Boot seals the reset button without hiding it. It's a clear cover, so you can still see the button and check whether a breaker has tripped at a glance.
This one fits Egis push-to-reset breakers with either spade or screw terminals. It replaces the standard mounting nut, so there's no extra hardware to source. You back off the factory nut, slip the boot over the button, and thread it down in its place. Takes about a minute per breaker.
The material is UV resistant, which matters more than it sounds. A boot that chalks and cracks after one season stops sealing, and then you're back to water in the breaker. This one holds up to sun and salt air, so the seal stays tight for the long haul.
Good fit for center console dashes, flybridge panels, and any open helm where the breakers live out in the weather. Sold as a retail pack.
Key Features
- Clear boot design lets you see the reset button and spot a tripped breaker at a glance
- UV-resistant material resists chalking and cracking, keeping the seal tight in sun and salt air
- Replaces the standard breaker mounting nut, so no extra hardware is needed to install
- Fits low-amp push-to-reset breakers with spade or screw terminals
- Sold as a retail pack
Why Buy from NVN Marine
- Authorized Egis Mobile Electronics reseller, full manufacturer warranty
- NMEA member and ABYC certified, advice from real boat techs
- Same-day shipping before 3 PM ET on in-stock items
- NY headquarters and Fort Lauderdale flagship retail store
Frequently Asked Questions
What breakers does this boot fit?
It fits Egis low-amp, panel-mount push-to-reset circuit breakers with either spade or screw terminals.
How does it mount?
It replaces the standard mounting nut on the breaker. You remove the factory nut and thread the boot down in its place, so there's no extra hardware to buy.
Can I see if a breaker has tripped with the boot on?
Yes. The boot is clear, so the reset button stays visible and you can check the breaker at a glance.
Will it hold up to sun and salt air?
The material is UV resistant, so it won't chalk or crack after a season out in the weather. That keeps the seal tight over the long haul.
Technical Specifications
| Title | EGIS Clear Button Boot Low Amp Panel Mount Push to Reset Breakers Retail Pack |
|---|---|
| Brand | Egis Mobile Electronics |
| Manufacturer Part Number | 4715 |
| UPC | 850074331216 |
| Category | Electrical |
| Material | UV Resistant |
| Compatibility | Push-to-reset spade and screw circuit breakers |
| Mounting | Replaces standard breaker mounting nut |
| Packaging | Retail Pack |