A complete, ready-to-install Nelson S7 Spinner assembly: flow-regulated spinner head, stake and 60cm feed tube in one unit. Push the stake in, connect the tube to your poly lateral and it is ready to water. Ideal for orchards, vineyards, shelterbelts, revegetation and garden beds.

Key features

• Flow regulated at 90 L/h: delivers a consistent output across the line, so plants at the end of a long run or up a slope get the same water as those near the supply.
• Modular design: nozzles and heads swap over in seconds without tools.
• Quick Clean (QC): twist off, flush and reconnect to clear blockages, cutting maintenance time in the field.
• Insect protection: built-in guard helps stop the head plugging or stalling.
• Optional break-off tab: reduces the wetted radius for young trees, then snap it off as they mature.
• Stake mounted: holds the head upright and lifts the feed tube clear of the ground.

Specifications

• Flow rate: 90 L/h (flow regulated)
• S7 range operating pressure: approx. 100 to 345 kPa (15 to 50 PSI)
• Wetted radius: approx. 2.7 to 4.9 m depending on nozzle and pressure
• Feed tube length: 60cm
• Nelson part no: 12983-030

What's included

• 1 x Nelson S7 Spinner head, 90 L/h flow regulated
• 1 x Stake
• 1 x 60cm feed tube with connector