This remote includes 3 Modes, from beginner to expert.

Charging time: 2-3 hours
Type: 2.4G RF Technology

The RF remote is better at smooth braking and acceleration and linear in speed control. The RF can adjust the braking. The RF has a longer throttling distance.

The RF remote is an improved controller with finer control of both acceleration and braking. Its new thumbwheel allows you to make small speed adjustments or mark acceleration depending on your needs. In addition, the brighter LEDs and larger buttons ensure that you always know your speed mode and charge level.

Features:

The brake can be remotely reconfigured by pressing different speed modes to adjust the brake soft or strong while pulling the throttle back fully. Low speed is soft braking setting, high speed is forced action, medium speed is normal braking, we strongly recommend.

2.4G RC7 remote control, 3 speed drive modes (low/medium/high speed)

Reverse direction button.

If any of our customers have purchased an ESCS or kit from us, they can purchase this new remote upgrade with 3 speed control and a better feeling of riding control.

This remote does not have a receiver and cannot be used with VESC.Its receiver is built into our ESC PCB, and this remote only works with our ESC.

The old Remote RC5 was smaller in size, this new Remote RC7 is a 3 speed mode with better performance and control feel, no need to buy a new ESC to upgrade your old ESC/kit/board, it is fully compatible with all old ESCs and past orders.Just need to sync/pair with ESC.

Note: This new remote control is designed for our ESCS, it may work with part of the Meepo board or ESCS, but we can't 100% ensure compatibility with other vendors' ESC work due to differences in the firmware and hardware of the receiver and transport protocol.

This remote control includes 3 speeds

Slow (8-10 MPH)

Medium (16 to 18 MPH)

Fast (18 to 25 MPH)

Slow - slow acceleration, slow top speed

Acceleration at medium to low speeds, with a higher top speed

Fast - Fast acceleration, maximum speed

Charging time :15-30 minutes

Time of use: 2 to 3 weeks on a full charge, or 12 to 15 rides on the board battery.

Charging connector :USB Mini(phone charger USD cable available)

Remote Pairing Command:

Turn off the board and remote control.
Open the board.
Long press the power button for 5- 7 seconds, until the power button light begins to flash.

Note: "With power still on, press the power button on the veneer again for 5-7 seconds for pairing to take effect."

Turn on the remote.
Using a thin stick, quickly press the recessed binding button on the remote control.
If you see the battery meter light up and a green light on the remote control, they're connected.