Continuo Decor — Professional Microcement Coating Kit (30-40 sq ft)

Continuo Decor by San Marco is a professional two-component epoxy microcement system for coating countertops, walls, floors, and other surfaces with a seamless, modern finish. This complete microcement kit covers 30-40 square feet — perfect for countertops, bathroom vanities, shower walls, accent walls, and small surfaces. Tintable to a wide variety of colors with effects ranging from flat monolithic to textured two-tone.

Why Choose Continuo Microcement

• Easier to use than most other microcement systems on the market
• Create finishes from smooth and uniform to textured with character
• Harder wearing than many other similar coatings — built for floors, countertops, and high-traffic surfaces
• Complete kit includes primer, decorative coat, link coat, and epoxy top coat

Continuo should be used as a system with proprietary primers and a two-component top coat. The Decor Kit includes all essential parts of the complete microcement system. Apply on a porous surface.

Continuo Style Guide

The Decor Kit Includes:

* Looking for more coverage? Check out our Continuo Living Kit (100-125 sq ft)

** Need more of a specific product? Call 608-620-5066

***Note: If applying on non-porous surface such as tile or stone, primer needs to change to Pro-Link or other appropriate primer for these surfaces.

Application Instructions:

*Email and request a manual for detailed specifications

These are basic guidelines — refer to manual for coverage, mixing ratios, and dry times

1. Sand substrate with 80 Grit to create a key
2. Dilute primer 1:1 and apply one coat, allow to dry
3. Optional - if surface needs to be leveled or tile grout lines filled, apply layer of Leveling Base to desired smoothness
4. Install mesh into wet Base and allow to dry (only if leveling base is used)
5. Cover over mesh with Levelling Base and allow to dry
6. Apply one coat of diluted primer. Allow to dry
7. Split Deco A and Deco B into two even parts, half each
8. Add one part Deco B Hardener to one part Deco A and stir (power mixing is recommended)
9. Apply Deco with stainless steel trowel to cover over Base and smoothen surface. Allow to dry
10. Apply 2nd layer of Deco A & B with stainless steel trowel to desired pattern. Allow to dry
11. Optional - sand with 300 grit sandpaper if desired (Clean)
12. Add Link B to Link A and stir. Dilute with water
13. Apply Link to surface with brush or roller and allow to dry
14. Add Top Coat B to Top Coat A and stir
15. Apply Top Coat by (trim in w/brush) roller all. Recommend two even uniform coats

Continuo Application Instructional Series