Tongue & Groove Flooring Router Bit Set – Make Hardwood Flooring up to 1-1/8" Thick

Woodworkers love to make custom flooring, and this matched 2-piece set is built for it. Mill your own hardwood flooring from stock up to 1-1/8" thick with a joint that goes together tight, board after board.

The tongue cutter features a 1/2° angle, which produces a slight gap at the bottom of the joint so the boards close up tight at the face. The tongue and groove cuts are also offset approximately 1/16" to allow room for expansion. Each set is C.N.C. machined to guarantee a perfect fit between the two bits, and we finish every bit with our silver non-stick coating for years of trouble-free service.

Features:

• Matched tongue and groove flooring set for stock up to 1-1/8" thick
• 1/2° tongue angle for a tight-fitting joint at the face
• Approx. 1/16" offset between tongue and groove allows room for expansion
• 1-1/8" cutting height
• Bearing-guided bits for easy setup
• 1/2" shank for stable cuts in the router table
• Silver non-stick coating

Need a different flooring joint? See the V-Tongue & Groove Router Bit Set (61-504) or the Floor Making Router Bit Set with Nail Slot (61-511).