Bedside Reading Light with a USB Port and Its Own Switch
This bedside reading light mounts on the wall, so the nightstand stays clear. A slim cylinder head sits on a flat rectangular plate and turns to aim the beam at the page. The switch is on the plate, within reach from bed. Below it is a USB port that puts out up to 2100 mA, so a phone charges overnight without another plug. The plate is 3.2 in wide and 9 in tall. Choose white or black, in three light colours.
| Product Type | Wall lamp |
| Light Source | Built-in LED |
| Backplate Size | 3.2 in wide x 9 in high x 1.2 in deep |
| Head Size | 4.1 in long x 1.6 in diameter |
| USB Output | DC 5V, up to 2100 mA |
| Switch | On the backplate |
| Colour Options | White or black |
| Light Colour Options | Warm white 3000K, neutral 4000K or cold white 6000K |
| Voltage | 100-260V |
| Product Weight | 1.8 lb |
A table lamp beside a bed takes up the surface you want for a glass of water and a book. This one goes on the wall instead. The head is a slim cylinder that turns, so the beam lands on the page rather than filling the room. The switch is on the plate, at hand height. A USB port sits below it and puts out up to 2100 mA, which is enough to charge a phone overnight.
A Beam That Stays on the Page
The head is a narrow cylinder, so the beam is tight rather than wide.
Turned down towards the book, very little light reaches the rest of the bed.
That is the difference between reading late and keeping someone awake.
The head is a narrow cylinder rather than an open shade.
That shapes the light into a cone instead of letting it spill.
Turned down onto a book, very little reaches the other side of the bed.
Turned out it becomes a small wall light instead.
The head is 4.1 in long and 1.6 in across.
It is set on the plate rather than on an arm, so it does not swing out.
Mount it at shoulder height when sitting up in bed.
Switch and USB Together
The rocker switch sits on the plate, so no cord hangs down.
The USB port below it removes one adapter from the bedside socket.
The rocker switch sits on the front of the plate.
That means no pull cord and no reaching for a wall switch.
The USB port is below the switch on the same face.
It puts out DC 5 volts at up to 2100 mA.
That is enough to charge a phone overnight at a normal rate.
It removes one adapter from the socket behind the bed.
Both the switch and the port are on the front, so nothing is hidden.
Size and Finish
The plate is 3.2 in wide and 9 in tall, so it suits a narrow gap.
White disappears into a pale wall; black stands against one.
The plate is 3.2 in wide, 9 in tall and 1.2 in deep.
It fits the narrow gap between a bed and a wardrobe.
White reads lightest and disappears against pale plaster.
Black holds its outline and suits a darker scheme.
Three light colours are offered from warm 3000K to cold 6000K.
Warm white is the usual pick beside a bed.
The LED is built in, so there is no lamp to replace.