Overview

The Carbitool Drill Guide Attachment turns your hand drill into a portable drill press. It holds the drill steady on twin steel guide rods so you can drill straight, square holes or set an exact angle anywhere across a 120° range.

It runs off a 1/4" hex drive, so it works with corded and cordless drills, and it takes bits up to Ø60mm. It suits woodworkers, furniture makers and tradies who need accurate holes in the workshop or on site.

Key Features

• Drill at a precise angle with good control across a 120° range.
• 1/4" hex drive suits both corded and cordless drills.
• Suits drill bits up to Ø60mm.
• Integral V guides let you drill round pipe and stock without it rolling.
• Base holes let you fix the guide to a jig or sub-base for extra stability.
• Integrated depth stop for accurate, repeatable hole depths.
• Cast aluminium base, machined slide assembly and steel guide rods for durable, smooth operation.
• Unobstructed view of your drilling mark before and during the cut.

Perfect For

• Drilling square, accurate holes in timber without a drill press.
• Angled holes for joinery, furniture making and cabinet making.
• Drilling round pipe, dowel and rail.
• Large panels and site work that will not fit under a drill press.
• Small workshops with no room for a pillar drill.

Why Choose the Carbitool Drill Guide?

Drilling a straight hole by hand is hard to get right, and drilling an accurate angle freehand is harder again. This guide gives your own drill the control of a drill press, with a wide 120° angle range, a depth stop and a solid cast aluminium base. Because it is portable, you take it to the work instead of taking the work to a machine.

Will It Work With My Drill?

Yes. The guide uses a 1/4" hex drive, so it suits corded and cordless drills.

Can I Drill Round Stock?

Yes. The integral V guides in the base locate round pipe and stock so you can drill through the centre.

Specifications