A freestanding, 1-person, single-walled Dyneema® tent
The CrossPeak 1 tent by Hyperlite Mountain Gear brings the same freestanding design and rock-solid stability of the proven CrossPeak 2 shelter. Dialed in to strike the optimal balance of weight, durability, waterproof protection, and roomy livability, it is a streamlined shelter made for solo adventures. This freestanding tent's small, sleek layout allows it to be pitched almost anywhere, from rocky and rooty soils to tent platforms or a small stealth camping spot. The CrossPeak 1 is made with a durable blend of Dyneema® Composite Fabrics, ensuring protection in all weather while keeping the weight of this tent minimal. Feel prepared for a variety of conditions with the ultralight CrossPeak 1 shelter.
Features:
Interior Accommodations: lots of headroom, one deep zippered vestibule, one storage pocket, clothesline attachment loops
Floor Plan: accommodates a wide sleeping pad with plenty of space for gear beside and below it
Waterproof, lightweight, and durable fabric
Aluminum poles are light, reliable, and strong and outperform carbon poles with a negligible weight penalty
External pole sleeves from 20D sil-nylon create a strong, reliable structure and make pitching smooth and consistent every time
Adjustable ventilation at the head and foot end allows for airflow to keep condensation at a minimum
Magnetic door tie-backs make tying back doors a breeze
In tough weather conditions, tent stability can be reinforced with trekking poles using the pole retention straps and additional guylines on the head and foot panel, and pole tie-out points
Reinforced tie-outs with high-visibility orange tie-out loops to provide critical structural reinforcement and added strength in challenging storms
Latter Locks allow for precise and easy tension adjustments, guaranteeing a taut and stable pitch every time
Reflective bindings and clearly marked pole intersections ensure quick, intuitive setup and easy tent location, even in the dark
Make sure campsite is clear from sticks, rocks, or other sharp pointed objects.
Remove shelter from the stuff sack and close the vestibule door zipper.
For optimal pitch, lay out shelter on flat, level ground.
Stake out each of the 4 corners at 90 degree angles from each other.
Adjust pole to a minimum pole height of 130cm (install pole jack to supplement height if necessary).
Unzip the door and insert the pole, placing the bottom of the pole through the loop sewn into the bottom of the bathtub floor.
Zip door.
Adjust the 2 front corners of the shelter so that the front corner seams become taut.
Adjust the 2 back corners of the shelter so that the back corner seams become taut.
Stake out the door tie-out, tighten.
Stake out rear perimeter tie-out enough to take any looseness out of the panel. DO NOT overtighten.
To increase stability in higher winds, we recommend attaching additional guyline to the front apex tie-out.
To mitigate panel deflection in higher winds, we recommend utilizing the 4 mid-panel tie-outs AND the pre-attached shock cord loops. DO NOT over-tension these points as to disfigure the pitch of the shelter.
Ventilation helps control condensation and temperature inside the tent.
Door can be rolled up to provide maximum air flow and visibility.
Unclip the door from the tie-out, roll it up, and store using the magnetic clasp.
Large vents on both side panels are adjustable by reshaping the plastic brim.
Care Instructions: Take the time on a dry, sunny day to spot-clean any areas that need it. A soft, damp cloth and a mild soap (non-detergent and non-oil-based soaps work well, do not bleach). Air-dry your tent by leaving it out to hang dry. Make sure your tent is completely dry before long-term storage.