A 3D printed Push Bike Wedding Name Stand, Bicycle Wedding Name Display, Cycle Shaped Place Holder, Seating Name Holder, Pedal Bike Wedding Name Holders, (for wedding / event / party seating) made with plastic PLA filament.

These are NOT metal. Photos of other stands used are just examples of colour options available.

Dimensions:

Height - 3.4 cm (34 mm)

Width - 5.8 cm (58 mm)

The stand is 3.4 cm height by 5.8 cm width approx (34 mm / 1.25 inches by 58 mm / 2.25 inch) and is 2 mm thick (across widest points). The base is 4 mm thick and 4 cm by 4 cm in area size. There are two prongs at the rear that support the name card in place. 

The front of the holders have a smooth finish. Due to the nature of 3d printing, some print lines will be visible. 

This is for the holder only - the cards are for display purposes. The largest card used in the photos is sized 21 cm (210 mm / 8.25 inches) height by 14.8 cm (148 mm / 5.75 inches) width and is 200 gsm cardstock. Please see photos for details. (Please Note - Actual colours may vary. This is due to the fact that every computer monitor has a different capability to display colours and that everyone sees these colours).

This is not a toy and cannot be placed in a dishwasher. Hand wash and wipe clean only.

Thank you for looking.

**The material is PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."***