A 3D printed plain name display holder (for wedding / events / party seating) made with PLA plastic filament. The front bar is 7 mm height by 37 mm (3.7 cm) width and is 1 mm thick (across widest point) and the base is 2 mm thick and 1.8 cm by 3.8 cm in area size. There are two small prongs of plastic at the rear that holds the name card in place.

The front of the holders have a smooth finish. These are NOT metal. Photos of other stands used are just examples of colour options available. Not suitable for card larger than a business card. 

Dimensions:

Height - 0.7 cm (7 mm)

Width - 3.7 cm (37 mm)

The stands are 7 mm height by 37 mm (3.7 cm) width and is 1 mm thick (across widest point) and the base is 2 mm thick and 1.8 cm by 3.8 cm.

This is for the holder only - the cards are for display purposes. The cards used in the photos are business card sized, which is 8.5 cm (85 mm / around 3.25 inches) by 5.5 cm (55 mm / just over 2 inches). Please see photos for details. (Please Note - Actual colours may vary. This is due to the fact that every computer monitor has a different capability to display colours and that everyone sees these colours).

This is not a toy and cannot be placed in a dishwasher. Hand wash and wipe clean only.

**The material is PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."***