3D printed Flaming Skull Place Card Holders, Flaming Skull Seating Name Place Holder (for wedding / event / party seating) made with plastic PLA filament. Suitable for business card sized name cards only. Bigger cards will topple the stands.

"PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."

These are NOT metal. Photos of other stands used are just examples of colour options available.

Dimensions:

Height - 2.8 cm (28 mm)

Width - 2 cm (20 mm)

The Skull shape is 2.8 cm high by 2 cm wide, and 2 mm thick approx (28 mm by 20 mm / 0.80 inches by 1 inch). The base size 1.8 cm by 2 cm. You can see the lines of the filament up close - please see images. There are two prongs of at the rear that support the name card in place.

This is for the holder only - the cards are just for display purposes. The cards used in the photos are business card sized, which is 8.5 cm (85 mm / around 3.25 inches) by 5.5 cm (55 mm / just over 2 inches). Please see photos for details.

Please ask if you would rather have in a different colour - most other colours can be available on request. (Actual colours may vary. This is due to the fact that every computer monitor has a different capability to display colours and that everyone sees these colours).

This is not a toy and cannot be placed in a dishwasher. Hand wash and wipe clean only.

**The material is PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."***