A 3D printed Push Bike Wedding Name Stand, Bicycle Wedding Name Display, Cycle Shaped Place Holder, Seating Name Holder, Pedal Bike Wedding Name Holders, (for wedding / event / party seating) made with plastic PLA filament.

These are NOT metal. Photos of other stands used are just examples of colour options available.

Dimensions:

Height - 2 cm (20 mm)

Width - 3.1 cm (31 mm)

The stand is 2 cm height by 3.1 cm width approx (20 mm / 0.75 inches by 31 mm / 1 inch) and is 2 mm thick (across widest points). The base is 2 mm thick and 1.8 cm by 2 cm in area size. There are two prongs at the rear that hold the name card in place. Suitable for a BUSINESS CARD sized piece of card. 

The front of the holders have a smooth finish. Due to the nature of 3d printing, some print lines will be visible. 

This is for the holder only - the cards are for display purposes. The cards used in the photos are business card sized, which is 8.5 cm (85 mm / around 3.25 inches) by 5.5 cm (55 mm / just over 2 inches). Please see photos for details. (Please Note - Actual colours may vary. This is due to the fact that every computer monitor has a different capability to display colours and that everyone sees these colours)

This is not a toy and cannot be placed in a dishwasher. Hand wash and wipe clean only.

Thank you for looking.

**The material is PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."***