Current Back Flange

This is the current back flange design and includes a pre-installed axle bushing. It replaces the back flange used on all earlier reel editions (1st–3rd editions). 

Important: This back flange will not connect to an older front flange. If you are upgrading a 3rd-edition or earlier reel, you must also order the item 4149 Front Flange.

Will It Fit My Reel?

This back flange was introduced in May 2017. Use the table below to confirm that it is compatible with your reel.

Reel model	Compatible serial numbers
1041 Wall-Mount	100001 or higher
1042 Free-Standing	200001 or higher
1043 Wheeled Cart	300002 or higher

Do I Need a New Hose Strap?

Reel edition	Hose strap requirement
1st–3rd edition	You must order the Item 4114 Hose Strap Assembly. The original hose strap or clamp will not work with this front flange.
4th–6th edition	You may reuse the hose strap from your original reel. Order Item 4114 only if your existing strap is broken, missing, or otherwise unusable.

 

Parts Needed by Reel Edition

4th edition or newer

• This back flange
• Item 4114 Hose Strap Assembly, only if your original hose strap is broken, missing, or otherwise unusable

3rd edition — April 2015 through May 2017

• This back flange
• Item 4149 Front Flange
• Item 4114 Hose Strap Assembly
• Item 4006 M6 × 20 Screws

Check your reel’s parts diagram for the correct screw quantity, as it varies by model.

1st or 2nd edition — May 2009 through April 2015 (Rapid Reel Models)

Order all the parts listed for a 3rd-edition reel, plus:

• Item 2654 Crank Handle

The older Item 2589 crank handle will not fit this flange.

Installation Notes

• A 5 mm hex key is the only tool required.
• Mounting nuts are embedded in 4th-edition and newer flanges, so separate cage nuts or lock nuts are not needed.

Return to the Parts Page