Magnetic Jumping Spider Hut for Arboreal Enclosures

A penthouse for your jumper. Corner unit, rooftop lounge, great views.

Give your jumper a compact upper-corner retreat without eating up floor space. This 3D printed PLA jumping spider hut is shaped to fit a 90-degree enclosure corner and mounts with two included magnets.

• Designed for jumping spider enclosures
• Upper-corner placement for an arboreal-style hide
• Flat top creates an additional perch or lounge area
• Branch-style access below the hut
• Two magnets included
• Compact size for micro terrariums and small spider enclosures

Made from durable PLA. The white version is a good choice for a DIY paint project; always use animal-safe paint and allow it to fully cure before use. Additional colors are ready to use as enclosure decor.

Approx. Dimensions (L × W × H): 1 in × 1 in × 0.75 in

Installation

• Connect the hut to the enclosure wall using the two included magnets.
• Install only in an empty enclosure for your spider’s safety.
• Slide the magnets and hut into position rather than allowing them to snap together, as a hard snap may crack or damage enclosure walls.

READY TO USE: Magnets included. Magnet colors may vary, typically black or silver.

Related setup idea: Pair the upper-corner hut with one of our floor-level Mushroom, Top Hat or Jack-O-Lantern terrarium hideouts for additional enclosure decor.

WARNING: Not a toy. Keep out of reach of children. Choking hazard.